Shandong Huaning Electric Heating Technology Co., Ltd.
Application of Huaning Electrical Insulation System in Metro
The electric heat preservation system consists of heating cables, temperature sensors and related control systems to ensure that the ideal effect is achieved with less energy consumption. The fire pipe of this system can accurately monitor the temperature automatically and reflect the ultra-high and ultra-low temperature alarms in the built-in control room. System control alarm types: ultra-high temperature pipeline, ultra-low temperature alarm, heating cable power failure and leakage alarm.
Apr 18,2023
In the water supply and drainage system of the first metro lines, the pipelines in the metro station are mainly based on the traditional heat preservation. With the continuous improvement of the requirements in the metro, the electric heating system is gradually applied, but there are not enough problems in the application process. However, after the reconstruction of the Tianjin Metro Line by Huanning and the gradual commissioning of several subway lines, the electric heating system has become widely used to protect the metro water supply and drainage equipment from cold and freezing.
The electric heat preservation system consists of heating cables, temperature sensors and corresponding control systems to achieve the ideal effect with less energy consumption. The fire pipe of this system can accurately monitor the temperature automatically and reflect the ultra-high and ultra-low temperature alarms in the built-in control room. System control alarm types: ultra-high temperature pipeline, ultra-low temperature alarm, heating cable power failure and leakage alarm.
\ n1. Ultra-low temperature protection: If the temperature of any of the two pipeline detection points is lower than 2 °C, the heating cable will start to heat up, and at the same time the on-site alarm light will be triggered and the remote alarm switch will be triggered.
2. Ultra-high temperature protection: When the cable is in the heating state, if the temperature of the two detection points of the pipeline is simultaneously higher than 10 °C, and at any point above 15 °C, the system will force the heating cable to stop heating, And at the same time send the alarm light and remote emergency switch to the object. If the cable is not heated, there will be no alarm.
3. Leakage protection: When the system detects that the heating cable leakage exceeds 30mA, when the heating cable is working, the system will send the alarm light to the object and the remote emergency switch to switch to the corresponding spare cable at the same time.
4. Overcurrent protection: When the system detects load current greater than 16A when the heating cable is running, the system will send a light alarm in place and a remote emergency switch to switch to the appropriate spare cable at the same time. Time.
5. Cable break protection: When the system sends a heat command but does not detect the load current, the system simultaneously sends an in-place light alarm and a remote emergency switch to switch to the appropriate spare cable.
6. Sensor Failure: When one of the two sensors at the pipeline detection point fails, the system maintains the heat preservation operation of that pipeline according to the data provided by the intact sensor, and sends a light alarm and remote emergency switch to the facility. In the event of a failure, the system stops the heating of the pipeline and provides a light alarm and a remote emergency switch to the object.
Related Posts
Electrical heating installation precautions
Electric heating cable is a heating method that uses insulation resistance or resistance heating wire to create a temperature after power supply. It can automatically adjust the output temperature and reasonably maintain the process temperature requirements to keep warm, raise the temperature and protect the heating equipment from freezing. The insulation and antifreeze effect of the container is very good.
Which electric heating should be chosen for the main pipeline transport of heavy oil
Transport of heavy oil through the pipeline over long distances and long-term retention in the pipeline will result in a drop in temperature due to heat dissipation and increased viscosity, which will cause the pipeline to be blocked by freezing or condensation-related accidents. Electric heating is widely used as effective insulation of pipelines and anti-freeze protection.
Which electric heating cable should be considered for a 4 km pipeline
According to the statistics of the Hydrometeorological Center, the average daily minimum temperature at the location of the CNPC tank farm is 5 ° C, and the average daily maximum temperature is 14 ° C. Since the freezing point of the PX is about 15 °C, the supply pipeline needs heat preservation and heating. The oil depot has been in operation for many years without a stable source of steam, therefore, this project is considering the use of electric heating technology.
Application of outdoor electric heating cable in oil main pipelines with high paraffin content
Long-distance crude oil pipelines with a high paraffin content with freezing temperatures above 50 °C. According to the requirements of the production plan of the plant, the volume of oil transportation through the pipeline is 150 thousand rubles. Tons per year, maximum-200 thousand. Tons per year.. According to the thermodynamic analysis of the pipeline, the initial supply temperature of the pipeline is 80 ° C (TN), and the temperature of the end entering the tank is 60 ° C (Tu). Since the transportation temperature needs to be adjusted according to the time of year, it sometimes needs to be transported by heat.
What heating product to choose for main infusion pipelines
In petrochemical engineering, trunk infusion pipelines are the lifeblood of the factories. The temperature in the northern region is too low in winter and the pipeline needs to be insulated to compensate for the heat loss due to the low temperature in winter to ensure the normal operation of the pipeline.
The role of leather tracer cables in the insulation of asphalt main pipelines
The toughness of the asphalt is greatly affected by the temperature. When the temperature decreases, the toughness of the asphalt increases, and the drop in resistance of the asphalt during pipeline transportation increases; when the temperature falls below the freezing point, the asphalt solidifies, causing the pipeline to clog and the conveyor belt to come to trouble. Therefore, electric heating and heat preservation during the transportation of asphalt are very important.
Need help to find the right solution with our experts?
WhatApp:
E-mail:
Address:
Xinxing Street, Industrial Park, Shanghe County, Jinan City, Shandong Province
✪ Huaning Electric Heat Tracing provides you with professional solutions
