Shandong Huaning Electric Heating Technology Co., Ltd.
Analysis of the choice of electric heating mode of mine water supply
In the northern regions of my country, the lowest temperature in winter is usually below minus 10 ° C, and most of the coal mines in my country are located in the northern regions. Under the influence of geological conditions and ambient temperature, the phenomena of splashing water and freezing of the borehole occur. The self-limiting temperature electric heating cable heats and insulates the water supply pipeline, features high reliability, low power consumption, easy installation and maintenance, and easy implementation of centralized automatic control.
May 25,2023
In the northern regions of my country, the lowest temperature in winter is usually below minus 10 °C, and most of the coal mines in my country are located in the northern regions. Under the influence of geological conditions and ambient temperature, the phenomena of splashing water and freezing of the borehole occur. Once the water supply lines located in the wellbore freeze, the normal safe operation of the mine will be seriously affected. The self-limiting temperature electric heating cable heats and insulates the water supply pipeline, features high reliability, low power consumption, easy installation and maintenance, and easy implementation of centralized automatic control.
Electric heating consists in the use of electric heating to compensate for the heat loss of the heated body (container, pipe, etc.) The goal of the lowest energy consumption and the lowest complex cost is based on the principle of optimal heat transfer distribution and low energy consumption. The form of heat dissipation is uniform heat dissipation in length or over a large area, and the temperature gradient is small and stable, which is suitable for long-term use.
The place where the heating cable is used is in the coal mine shaft, and the product must meet the explosion-proof standard of the coal mine. Huaning heating cable can be used in explosive (classified) locations and in tropical explosive environments.
The electric heating has a small volume, a large contact area, and small transmission losses, while in steam heating and hot water heating, it is necessary to add heating lines to contact and transfer heat, and the transmission losses are large.
The electric heating has a small volume, a large contact area, and small transmission losses, while in steam heating and hot water heating, it is necessary to add heating lines to contact and transfer heat, and the transmission losses are large.
The electric heating can be controlled automatically, but the steam and hot water heating is difficult to automatically monitor and adjust the heating heat according to the temperature change of the pipeline to adapt to the seasonal and daily changes in ambient temperature, and the excess heat caused by the temperature change at the beginning and end. and compensate along the way. The integrated thermal efficiency of electric heating is very high. According to the statistics of the ten largest power plants in the country, integrated thermal efficiency from power plants to consumers (pipes, containers, etc. E.) is 29.4 ~ 35%, and the efficiency of heating electric heating is close to 100%.
Related Posts
Electrical heating installation precautions
Electric heating cable is a heating method that uses insulation resistance or resistance heating wire to create a temperature after power supply. It can automatically adjust the output temperature and reasonably maintain the process temperature requirements to keep warm, raise the temperature and protect the heating equipment from freezing. The insulation and antifreeze effect of the container is very good.
Which electric heating should be chosen for the main pipeline transport of heavy oil
Transport of heavy oil through the pipeline over long distances and long-term retention in the pipeline will result in a drop in temperature due to heat dissipation and increased viscosity, which will cause the pipeline to be blocked by freezing or condensation-related accidents. Electric heating is widely used as effective insulation of pipelines and anti-freeze protection.
Which electric heating cable should be considered for a 4 km pipeline
According to the statistics of the Hydrometeorological Center, the average daily minimum temperature at the location of the CNPC tank farm is 5 ° C, and the average daily maximum temperature is 14 ° C. Since the freezing point of the PX is about 15 °C, the supply pipeline needs heat preservation and heating. The oil depot has been in operation for many years without a stable source of steam, therefore, this project is considering the use of electric heating technology.
Application of outdoor electric heating cable in oil main pipelines with high paraffin content
Long-distance crude oil pipelines with a high paraffin content with freezing temperatures above 50 °C. According to the requirements of the production plan of the plant, the volume of oil transportation through the pipeline is 150 thousand rubles. Tons per year, maximum-200 thousand. Tons per year.. According to the thermodynamic analysis of the pipeline, the initial supply temperature of the pipeline is 80 ° C (TN), and the temperature of the end entering the tank is 60 ° C (Tu). Since the transportation temperature needs to be adjusted according to the time of year, it sometimes needs to be transported by heat.
What heating product to choose for main infusion pipelines
In petrochemical engineering, trunk infusion pipelines are the lifeblood of the factories. The temperature in the northern region is too low in winter and the pipeline needs to be insulated to compensate for the heat loss due to the low temperature in winter to ensure the normal operation of the pipeline.
The role of leather tracer cables in the insulation of asphalt main pipelines
The toughness of the asphalt is greatly affected by the temperature. When the temperature decreases, the toughness of the asphalt increases, and the drop in resistance of the asphalt during pipeline transportation increases; when the temperature falls below the freezing point, the asphalt solidifies, causing the pipeline to clog and the conveyor belt to come to trouble. Therefore, electric heating and heat preservation during the transportation of asphalt are very important.
Need help to find the right solution with our experts?
WhatApp:
E-mail:
Address:
Xinxing Street, Industrial Park, Shanghe County, Jinan City, Shandong Province
✪ Huaning Electric Heat Tracing provides you with professional solutions
